Toyota Camry Manual page 2529

New Gasket
SST
Fulcrum Length
CORRECT
O–Ring
Injector
Delivery Pipe
Grommet
SFI (5S–FE)
(b)
S05523
(c)
30 cm
NOTICE:
Do not rotate the fuel pipe, when tightening the flare nut.
FI1654
HINT:
Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).
(d)
WRONG
FI0420
– SFI SYSTEM
When connecting the union bolt on the high pressure pipe
union, observe these procedures:
(1) Always use 2 new gaskets.
(2) Tighten the union bolt by hand.
(3) Tighten the union bolt to the specified torque.
Torque: 29 N·m (300 kgf·cm, 21 ft·lbf)
When connecting the flare nut on the high pressure pipe
union, observe these procedures:
(1) Apply a light coat of engine oil to the flare nut, and
tighten the flare nut by hand.
(2) Using SST, tighten the flare nut to specified torque.
SST 09631–22020
Torque: 28 N·m (285 kgf·cm, 21 ft·lbf) for using SST
Observe these precautions when removing and installing
the injectors.
(1) Never reuse the O–ring.
(2) When placing a new O–ring on the injector, take
care not to damage it in any way.
(3) Coat a new O–ring with spindle oil or gasoline be-
fore installing–never use engine, gear or brake oil.
Author :
SF–3
Date :
1436