DI–882
INSPECTION PROCEDURE
1
Check resistance between terminals MO and MC of actuator motor.
ON
2
I00004
OK
2
Check for open and short in harness and connectors between cruise control
ECU and actuator motor (See page IN–31).
OK
Check and replace cruise control ECU.
(See page IN–31).
DIAGNOSTICS
PREPARATION:
(a)
Turn ignition switch ON.
(b)
Disconnect the actuator connector.
CHECK:
1
Measure resistance between terminals 1 and 2.
HINT:
If control plate is in fully opened or fully closed positions, resis-
tance can not be measured.
OK:
I00151
Resistance: more than 4.2 Ω
NG
NG
–
CRUISE CONTROL SYSTEM
Replace cruise control actuator.
Repair or replace harness or connector.
Author :
Date :
1117