Toyota Camry Manual page 1679

DI–652
5 Check spiral cable.
Spiral
Cable
D Squib
(–) (+)
H01000
R14301
OK
6 Check harness between airbag sensor assembly and spiral cable.
Spiral
Cable
D Squib
(–) (+)
H01004
R14301
OK
From the results of the above inspection, the malfunctioning part can now be considered normal.
To make sure of this, use the simulation method to check. If the malfunctioning part can not be
detected by the simulation method, replace all SRS components including the wire harness.
DIAGNOSTICS
PREPARATION:
Disconnect the connector between the airbag sensor assembly
and the spiral cable.
Airbag
Sensor
CHECK:
Assembly
For the connector (on the spiral cable side) between the steer-
ing wheel pad and the spiral cable, measure the resistance be-
tween D+ and body ground.
OK:
D+ Resistance: 1 MΩ or Higher
H01129
NG
CHECK:
For the connector (on the spiral cable side) between the spiral
cable and airbag sensor assembly, measure the resistance be-
tween D+ and body ground.
Airbag
Sensor
OK:
Assembly
Resistance: 1 MΩ or Higher
D+
NG
H06304
– SUPPLEMENTAL RESTRAINT SYSTEM
Repair or replace spiral cable.
Repair or replace harness between airbag sen-
sor assembly and spiral cable.
Author : Date :
887