Toyota Camry Manual page 2061

EM–62
ENGINE MECHANICAL (5S–FE)
25.
Wire
(a)
Clamp
(b)
S05548
(c)
(d)
(e)
(f)
26.
27.
(a)
Sensor
(b)
Connector
Clamp
(c)
(d)
S05297
(e)
(f)
(g)
(h)
S05281
– CYLINDER HEAD
INSTALL IGNITION COILS AND NO.2 INTAKE MAN-
IFOLD STAY ASSEMBLY
TMC Made:
Install the 2 ignition coils and manifold stay assembly with
the 2 nuts and 2 bolts.
Torque:
21 N·m (214 kgf·cm, 15 ft·lbf) for 12 mm head
42 N·m (428 kgf·cm, 31 ft·lbf) for 14 mm head
TMMK Made:
Install the 2 ignition coils and manifold stay assembly with
the nut and 3 bolts.
Torque:
21 N·m (214 kgf·cm, 15 ft·lbf) for 12 mm head
42 N·m (428 kgf·cm, 31 ft·lbf) for 14 mm head
Install the wire clamp to the manifold stay.
Connect the 4 high–tension cords to the spark plugs.
Install the 4 high–tension cords to the 2 clamps on the cyl-
inder head cover.
Connect the 2 ignition coil connectors.
INSTALL THROTTLE BODY (See page SF–34)
INSTALL EXHAUST MANIFOLD
California:
Install the A/F sensor connector for the wiring side to the
bracket to the LH engine hanger.
Except California:
Install the heated oxygen sensor for the wiring side to the
bracket to the LH engine hanger.
Attach the exhaust manifold to the front exhaust pipe.
Install a new gasket, the exhaust manifold, No.2 and No.3
exhaust manifold heat insulators assembly with the 6
nuts. Uniformly tighten the nuts in several passes.
Torque: 49 N·m (500 kgf·cm, 36 ft·lbf)
Install the wire clamp.
California:
Connect the A/F sensor connector.
Except California:
Connect the heated oxygen sensor (bank 1 sensor 1)
connector.
Install the No.1 exhaust manifold stay with the 2 bolts.
Torque: 42 N·m (425 kgf·cm, 31 ft·lbf)
Author : Date :
1234