Toyota Camry Manual page 1987

EC–6
Type A
Type B
B01082
B04812
Vacuum
Gauge
DLC3
EMISSION CONTROL (1MZ–FE)
INSPECTION
1.
Visually check for loose connections, sharp bends or damage.
2.
Visually check for deformation, cracks or fuel leakage.
3.
Visually check if the cap and/or gasket are deformed or dam-
aged.
If necessary, repair or replace the cap.
Gasket
Gasket
B06707
4.
(a)
(b)
B06544
(c)
TOYOTA
Hand–Held Tester
S05331
– EVAPORATIVE EMISSION (EVAP) CONTROL SYSTEM
INSPECT LINES AND CONNECTORS
INSPECT FUEL TANK FILLER PIPE
INSPECT FUEL TANK CAP
INSPECT EVAP SYSTEM LINE
Warm up the engine and stop the engine.
Allow the engine to warm up to normal operating tempera-
ture.
Install a vacuum gauge (EVAP control system test equip-
ment vacuum gauge) to the EVAP service port on the
purge line.
TOYOTA Hand–Held Tester:
Forced driving of the VSV for the EVAP.
(1) Connect a TOYOTA hand–held tester to the DLC3.
(2) Start the engine.
(3) Push the TOYOTA hand–held tester main switch
ON.
(4) Use the ACTIVE TEST mode on the TOYOTA
hand–held tester to operate the VSV for the EVAP.
Author :
EC0AV–01
Date :
1421