Toyota Camry Manual page 2330

C
C
A
C B
MANUAL TRANSAXLE (S51)
23.
A
(a)
(b)
C
A A
B
Q10008
24.
Using a transmission jack, support the transaxle.
25.
Remove the 3 bolts and LH stiffener plate.
Q10011
26.
(a)
(b)
(c)
Q10009
27.
Lower the engine left side and remove the transaxle from the
engine.
HINT:
At the time of installation, please refer to the following items.
L
L
– MANUAL TRANSAXLE UNIT
REMOVE FRONT SUSPENSION MEMBER WITH LOW-
ER SUSPENSION ARM
Remove the LH and RH fender liner set screws.
Remove the 6 bolts, 4 nuts, front LH and RH suspension
member braces, rear LH and RH suspension member
braces and front suspension member with the lower sus-
pension arm.
Torque:
Bolt A: 181 N·m (1,850 kgf·cm, 134 ft·lbf)
Bolt B: 32 N·m (330 kgf·cm, 24 ft·lbf)
Nut C: 36 N·m (370 kgf·cm, 27 ft·lbf)
JACK UP TRANSAXLE SLIGHTLY
REMOVE LH STIFFENER PLATE
Torque: 37 N·m (380 kgf·cm, 27 ft·lbf)
REMOVE REAR END PLATE WITH OIL PAN INSULA-
TOR AND RH STIFFENER PLATE
Remove the 2 bolts and rear end plate with the oil pan in-
sulator.
Torque: 9.3 N·m (95 kgf·cm, 82 in.·lbf)
Remove the 2 bolts and manifold stay.
Torque: 39 N·m (400 kgf·cm, 29 ft·lbf)
Remove the 4 bolts and RH stiffener plate.
Torque: 39 N·m (400 kgf·cm, 29 ft·lbf)
REMOVE TRANSAXLE
Align the input shaft with the clutch disc and install the
transaxle to the engine.
Temporarily tighten the transaxle mounting bolts.
Author :
MX–7
Date :
1857