MX–16
FIPG
SST
MANUAL TRANSAXLE (E153)
19.
Remove the 17 bolts and tap the case with a plastic hammer.
Q05815
20.
HINT:
At the time of reassembly, please refer to the following item.
Install the previously selected shim by adjusting output shaft
preload.
(See page MX–22)
MT0669
21.
Using SST and a hammer, remove the output shaft rear taper
roller bearing outer race.
22.
(a)
(b)
MT0693
23.
Remove the bolt and pull off the reverse shift arm and bracket.
24.
Pull out the shaft, and remove the reverse idler gear and thrust
washer.
Q06375
HINT:
Matchmarks
At the time of reassembly, please refer to the following item.
Align the matchmarks, as shown.
Z17557
–
MANUAL TRANSAXLE ASSEMBLY
REMOVE TRANSMISSION CASE
FIPG:
Part No. 08826 – 00090, THREE BOND 1281 or equiva-
lent
Torque: 29 N·m (300 kgf·cm, 22 ft·lbf)
REMOVE SHIM
REMOVE OUTPUT SHAFT REAR TAPER ROLLER
BEARING OUTER RACE
SST
09316–60011 (09316–00011)
REMOVE TRANSMISSION OIL PIPE
Remove the gasket from the oil pipe.
Remove the 2 bolts and oil pipe.
Torque: 17 N·m (175 kgf·cm, 13 ft·lbf)
REMOVE REVERSE SHIFT ARM BRACKET AS-
SEMBLY
Torque: 17 N·m (175 kgf·cm, 13 ft·lbf)
REMOVE REVERSE IDLER GEAR AND SHAFT
Author :
Date :
1817