Toyota Camry Manual page 1762

3 Check airbag sensor assembly.
Airbag
Sensor
P/T Squib (RH)
Assembly
PR+ PR–
DLC1
E1
Tc
H01020
H02139
AB0118 AB0119
R13006 H01083
OK
DIAGNOSTICS
PREPARATION:
(a)
(b)
(c)
ACC ON
CHECK:
(a)
or
(b)
DTC B0131/64
(c)
(d)
(e)
H02206
OK:
HINT:
Codes other than code B0131/64 may be output at this time, but
they are not relevant to this check.
– SUPPLEMENTAL RESTRAINT SYSTEM
Connect the connector to the airbag sensor assembly.
Using a service wire, connect PR+ and PR– of the con-
nector (on the seat belt pretensioner side) between the
seat belt pretensioner (RH) and the airbag sensor assem-
bly.
Connect negative (–) terminal cable to the battery, and
wait at least for 2 seconds.
Turn ignition switch to ACC or ON and wait at least for 20
seconds.
Clear DTC stored in memory.
(See page DI–626)
Turn ignition switch to LOCK, and wait at least for 20 se-
conds.
Turn ignition switch to ACC or ON, and wait at least for 20
seconds.
Check DTC.
(See page DI–626)
DTC B0131/64 is not output.
NG Replace airbag sensor assembly.
Author :
DI–735
Date :
970