Toyota Camry Manual page 1670

4 Check D squib.
Spiral
Cable
D Squib
ACC ON
or
DLC1
E1 Tc
H01003
AB0118 AB0119
FI1390
R13006
OK
From the results of the above inspection, the malfunctioning part can now be considered normal.
To make sure of this, use the simulation method to check.
DIAGNOSTICS
PREPARATION:
(a)
(b)
Airbag
Sensor
(c)
Assembly
(d)
CHECK:
(a)
(b)
DTC B0100/13
(c)
(d)
(e)
(f)
H01136
OK:
HINT:
Codes other than code B0100/13 may be output at this time, but
they are not relevant to this check.
– SUPPLEMENTAL RESTRAINT SYSTEM
Turn ignition switch to LOCK.
Disconnect negative (–) terminal cable from the battery,
and wait at least for 90 seconds.
Connect the steering wheel pad connector.
Connect negative (–) terminal cable to the battery, and
wait at least for 2 seconds.
Turn ignition switch to LOCK, and wait at least for 20 se-
conds.
Turn ignition switch to ACC or ON, and wait at least for 20
seconds.
Clear DTC stored in memory.
(See page DI–626)
Turn ignition switch to LOCK, and wait at least for 20 se-
conds.
Turn ignition switch to ACC or ON, and wait at least for 20
seconds.
Check DTC.
(See page DI–626)
DTC B0100/13 is not output.
NG Replace steering wheel pad.
Author :
DI–643
Date :
878