Toyota Camry Manual page 1890

INSPECTION PROCEDURE
1 Check Door Unlock Detection Switch.
UNLOCK
4
(–) (+)
I00273
I00274
OK
2 Check harness and connectors between ECU and door unlock detection switch,
door unlock detection switch and body ground (See page IN–31).
OK
Check and replace theft deterrent ECU.*1
DIAGNOSTICS
PREPARATION:
(a)
(b)
CHECK:
Check continuity between terminals 1 and 4 of door unlock
LOCK
detection switch connector, when the door lock knob is oper-
ated to the lock side and unlock side.
OK:
1
I00278
*1: When there is a malfunction that the theft deterrent system
cannot be set, proceed to the next numbered circuit inspection
shown on problem symptoms table (See page DI–837).
– THEFT DETERRENT SYSTEM
Remove the door trim and service hole cover.
Disconnect door unlock detection switch connector.
Switch Condition
Door unlock
Door lock
NG Replace door unlock detection switch.
NG Repair or replace harness or connector.
Author :
Tester connection Specified condition
1 – 4
–
Date :
DI–863
Continuity
No continuity
1098