Toyota Camry Manual page 2018

SST
Pull
Turn
Pull
Turn
ENGINE MECHANICAL (5S–FE)
13.
(a)
HINT:
S05589
HINT:
When re–using timing belt:
After loosing the crankshaft pulley bolt and matching the ditch
of the crankshaft pulley with the "0" of the timing mark of No.1
timing belt cover, check that matching mark meets.
A02586
When matchmark is misaligned clockwise:
If the matchmark does not align, align as follows:
A02587
Hold
Turn
A02588
When matchmark is misaligned counterclockwise:
If the matchmark does not align, align as follows:
A02589
– TIMING BELT
REMOVE CRANKSHAFT PULLEY
Using SST (and bolt), loosen the pulley bolt.
SST 09213–54015 (91651–60855), 09330–00021
Either of 2 types of pulley may be used, each with its own
bolt size, type A (91651–60885) and type B (part No.
91121–40665).
When using bolt type B, a plate washer must be inserted
between the bolt and SST.
(1) Align the matchmark by pulling the timing belt up on
the water pump pulley side while turning the crank-
shaft pulley counterclockwise.
(2) After aligning the matchmark, hold the timing belt.
And turn the crankshaft pulley clockwise, and align
its groove with timing mark "0" of the No.1 timing belt
cover.
(1) Align the matchmark by pulling the timing belt up on
the No.1 idler pulley side while turning the crank-
shaft pulley clockwise.
Author :
EM–19
Date :
1191