Toyota Camry Manual page 1816

2 Check source voltage.
Airbag Sensor Assembly
ON
ACC
(–) (+)
AB0119
H01298
OK
3 Does SRS warning light turn off?
ON
YES
From the results of the above inspection, the malfunctioning part can now be considered normal.
To make sure of this, use the simulation method to check.
DIAGNOSTICS – SUPPLEMENTAL RESTRAINT SYSTEM
PREPARATION:
Connect negative (–) terminal cable to the battery.
CHECK:
(a) Turn ignition switch ON.
(b) Measure the voltage each of IG2 and ACC on the sensor
IG2
and operate electric system. (defogger, wiper, headlight,
heater blower, etc.)
OK:
Voltage: 10 – 14 V
H01299
NG Check harness between battery and airbag sen-
sor assembly, and check battery and charging
system.
PREPARATION:
(a) Turn ignition switch to LOCK.
(b) Connect the steering wheel pad connector.
(c) Connect the front passenger airbag assembly connector.
(d) Connect the airbag sensor assembly connectors.
(e) Connect the side airbag assembly connectors.
(f) Connect the seat belt pretensioner connectors.
(g) Connect the side airbag sensor assembly connectors.
(h) Connect the front airbag sensor connectors.
H01249
(i) Turn ignition switch to ON.
CHECK:
Operate electric system (defogger, wiper, headlight, heater
blower, etc.) and check that SRS warning light goes off.
NO Check for DTCs. If a DTC is output, perform trou-
bleshooting for the DTC. If a normal code is out-
put, replace airbag sensor assembly.
Author : Date :
DI–789
1024