Toyota Camry Manual page 2402

MX–36
SST
MANUAL TRANSAXLE (E153)
REASSEMBLY
HINT:
Coat all of the sliding and rotating surfaces with gear oil before
reassembly.
1.
Front
(a)
(b)
NOTICE:
Position the key springs so that their end gaps are not
Q00384
aligned.
2.
(a)
(b)
(c)
Z00225
(d)
Z00385
3.
(a)
(b)
Z00386
– OUTPUT SHAFT
INSTALL NO.1 CLUTCH HUB INTO HUB SLEEVE
Install the clutch hub and shifting keys to the hub sleeve.
Install the shifting key springs under the shifting keys.
INSTALL NEEDLE ROLLER BEARING, 1ST GEAR,
SYNCHRONIZER RING AND NO.1 HUB SLEEVE TO
OUTPUT SHAFT
Apply MP grease to the needle roller bearing.
Install the 1st gear.
Place the synchronizer ring (for the 1st gear) on the gear
and align the ring slots with the shifting keys.
Using SST and a press, install the 1st gear and No.1 hub
sleeve.
SST 09316–60011 (09316–00041)
INSTALL SNAP RING
Select a snap ring that allows the minimum axial play.
Mark Thickness mm (in.)
A 2.80 (0.1102)
B 2.85 (0.1122)
C 2.90 (0.1142)
D 2.95 (0.1161)
Using a snap ring expander, install the snap ring.
Author :
Mark Thickness mm (in.)
E 3.00 (0.1181)
F 3.05 (0.1201)
G 3.10 (0.1220)
– –
Date :
MX05D–01
1837