Toyota Camry Manual page 2094

ENGINE MECHANICAL (5S–FE)
No.1 No.2 No.3 No.4 No.5
No.5
No.4
Mark
No.3
0, 1 or 2
No.2
No.1
Mark
1, 2, 3, 4, or 5
–
HINT:
If using a standard bearing, replace it with one having the same
number. If the number of the bearing cannot be determined, se-
lect the correct bearing by adding together the numbers im-
Mark
printed on the cylinder block and crankshaft, then selecting the
1, 2 or 3
bearing with the same number as the total. There are 5 sizes
of standard bearings, marked "1", "2", "3", "4" and "5" according-
ly.
Cylinder block
Crankshaft
Use bearing
EXAMPLE: Cylinder block "2" + Crankshaft "1"
Reference
Cylinder block main journal bore diameter:
Z00060
Mark "1"
Mark "2"
Mark "3"
Crankshaft main journal diameter:
Mark "0"
Mark "1"
Mark "2"
Standard sized bearing center wall thickness:
No.3
Mark "1"
Mark "2"
Mark "3"
Mark "4"
Mark "5"
Others
Mark "1"
Mark "2"
Mark "3"
Mark "4"
Mark "5"
(k) Complately remove the Plastigage.
19. REMOVE CRANKSHAFT
(a) Lift out the crankshaft.
(b) Remove the 5 upper bearings and 2 upper thrust washers
from the cylinder block.
HINT:
Arrange the main bearing caps, bearings and thrust washers in
the correct order.
CYLINDER BLOCK
1
0 1
1 2
= Total number 3 (Use bearing "3")
59.020 – 59.026 mm (2.3236 – 2.3239 in.)
59.026 – 59.032 mm (2.3239 – 2.3241 in.)
59.032 – 59.038 mm (2.3241 – 2.3243 in.)
54.998 – 55.003 mm (2.1653 – 2.1655 in.)
54.993 – 54.998 mm (2.1651 – 2.1653 in.)
54.988 – 54.993 mm (2.1649 – 2.1651 in.)
1.992 – 1.995 mm (0.0784 – 0.0785 in.)
1.995 – 1.998 mm (0.0785 – 0.0787 in.)
1.998 – 2.001 mm (0.0787 – 0.0788 in.)
2.001 – 2.004 mm (0.0788 – 0.0789 in.)
2.004 – 2.007 mm (0.0789 – 0.0790 in.)
1.997 – 2.000 mm (0.0786 – 0.0787 in.)
2.000 – 2.003 mm (0.0787 – 0.0789 in.)
2.003 – 2.006 mm (0.0789 – 0.0790 in.)
2.006 – 2.009 mm (0.0790 – 0.0791 in.)
2.009 – 2.012 mm (0.0791 – 0.0792 in.)
Author :
Number marked
2 3
2 0 1 2 0 1
3 2 3 4 3 4
Date :
EM–95
2
5
1267