Toyota Camry Manual page 1779

DI–752
4 Check P/T squib (LH).
Airbag
Sensor
P/T Squib (LH)
Assembly
ACC ON
or
DLC1
E1 Tc
H01018
AB0118 AB0119
R13006 H01084
OK
From the results of the above inspection, the malfunctioning part can now be considered normal.
To make sure of this, use the simulation method to check. If the malfunctioning part can not be
detected by the simulation method, replace all SRS components including the wire harness.
DIAGNOSTICS
PREPARATION:
(a)
(b)
(c)
(d)
CHECK:
(a)
(b)
DTC B0137/71
(c)
(d)
(e)
OK:
H01220
HINT:
Codes other than code B0137/71 may be output at this time, but
they are not relevant to this check.
NG
– SUPPLEMENTAL RESTRAINT SYSTEM
Turn ignition switch to LOCK.
Disconnect negative (–) terminal cable from the battery,
and wait at least for 90 seconds.
Connect the seat belt pretensioner (LH) connector.
Connect negative (–) terminal cable to the battery, and
wait at least for 2 seconds.
Turn ignition switch to ACC or ON, and wait at least for 20
seconds.
Clear DTC stored in memory.
(See step 5 on page DI–626)
Turn ignition switch to LOCK, and wait at least for 20 se-
conds.
Turn ignition switch to ACC or ON, and wait at least for 20
seconds.
Check DTC.
(See page DI–626)
DTC B0137/71 is not output.
Replace seat belt pretensioner (LH).
Author : Date :
987