Toyota Camry Manual page 2597

Retainer
Click Sound
TOYOTA
Hand–Held Tester
SFI (1MZ–FE) – SFI SYSTEM
(g) Observe these precautions when connecting the fuel
tube connector (quick type).
(1) Do not reuse the retainer removed from the pipe.
(2) Must use hands without using tools when to remove
the retainer from the pipe.
(3) Check if there is any damage or foreign objects on
the connected part of the pipe.
S05382
(4) Match the axis of the connector with axis of the pipe,
and push in the connector until the retainer makes
a "click" sound. In case that the connections is tight,
apply little amount of new engine oil on the tip of the
pipe.
(5) After having finished the connection, check if the
pipe and the connector are securely connected by
pulling them.
(6) Check if there is any fuel leakage.
S05050
(h) Observe these precautions when handling nylon tube.
(1) Pay attention not to turn the connected part of the
nylon tube and the quick connector with force when
connecting them.
(2) Pay attention not to kink the nylon tube.
(3) Do not remove the EPDM protector on the outside
of the nylon tube.
(4) Must not close the piping with the nylon tube by
bending it.
(i) Check that there are no fuel leaks after doing mainte-
nance anywhere on the fuel system.
(1) Connect a TOYOTA hand–held tester to the DLC3.
(2) Turn the ignition switch ON and push the TOYOTA
hand–held tester main switch ON.
NOTICE:
Do not start the engine.
(3) Select the active test mode on the TOYOTA hand–
held tester.
S05358
(4) Please refer to the TOYOTA hand–held tester oper-
ator's manual for further details.
(5) If you have no TOYOTA hand–held tester, connect
the positive (+) and negative (–) leads from the bat-
tery to the fuel pump connector.
(See page SF–6)
(6) Check that there are no leaks from any part of the
fuel system.
(7) Turn the ignition switch to LOCK.
(8) Disconnect the TOYOTA hand–held tester from the
DLC3.
Author : Date :
SF–5
1504