Toyota Camry Manual page 2352

Hide thumbs Also See for Camry:

Table of Contents

MANUAL TRANSAXLE (S51)

INSPECT 1ST AND 2ND GEARS THRUST CLEAR-

Using a feeler gauge, measure the thrust clearance.

Standard clearance:

1st gear: 0.10 – 0.29 mm (0.0039 – 0.0114 in.)

2nd gear: 0.20 – 0.44 mm (0.0079 – 0.0173 in.)

Maximum clearance:

1st gear: 0.35 mm (0.0138 in.)

2nd gear: 0.50 mm (0.0197 in.)

INSPECT 1ST AND 2ND GEARS RADIAL CLEAR-

Using a dial indicator, measure the radial clearance between

the gear and shaft.

Standard clearance:

0.009 – 0.053 mm (0.0004 – 0.0021 in.)

Maximum clearance:

0.070 mm (0.0028 in.)

If the clearance exceeds the maximum, replace the gear,

needle roller bearing or shaft.

REMOVE REAR BALL BEARING, 4TH DRIVEN GEAR

AND OUTPUT GEAR SPACER

Using SST and a press, remove the rear ball bearing and

4th driven gear.

Remove the output gear spacer and ball.

REMOVE 3RD DRIVEN GEAR, 2ND GEAR, NEEDLE

ROLLER BEARING AND SYNCHRONIZER RING

Shift the No.1 hub sleeve into the 1st gear.

Using SST and a press, remove the 3rd driven gear and

Remove the needle roller bearing and synchronizer rings.

OUTPUT SHAFT

Show Quick Links

Table of Contents