Toyota Camry Manual page 2104

SST
Pry
SST
ENGINE MECHANICAL (5S–FE)
(b)
(c)
20.5 mm
A07352
(d)
NOTICE:
Excess honing will destroy the finished roundness.
3.
HINT:
There are 2 methods ((a) and (b)) to replace the oil seal.
(a)
S01546
(b)
Cut Position
NOTICE:
Be careful not to damage the crankshaft. Tape the screw-
driver tip.
S05573
S05572
– CYLINDER BLOCK
Using a micrometer, measure the piston diameter at right
angles to the piston pin center line, 20.5 mm (0.807 in.)
from the piston head.
Calculate the amount of each cylinder is to be rebored as
follows:
Size to be rebored = P + C – H
P = Piston diameter
C = Piston oil clearance
0.175 – 0.195 mm (0.0068 – 0.0076 in.)
H = Allowance for honing
0.02 mm (0.0008 in.) or less
Bore and hone the cylinders to calculated dimensions.
Maximum honing: 0.02 mm (0.0008 in.)
REPLACE CRANKSHAFT FRONT OIL SEAL
If the oil pump is removed from the cylinder block:
(1) Using a screwdriver and hammer, tap out the oil
seal.
(2) Using SST and a hammer, tap in a new oil seal until
its surface is flush with the oil pump body edge.
SST 09226–10010
(3) Apply MP grease to the oil seal lip.
If the oil pump is installed to the cylinder block:
(1) Using a knife, cut off the oil seal lip.
(2) Using a screwdriver, pry out the oil seal.
(3) Apply MP grease to a new oil seal lip.
(4) Using SST and a hammer, tap in the oil seal until its
surface is flush with the oil pump body edge.
SST 09226–10010
Author :
EM–105
Date :
1277