Toyota Camry Manual page 2348

Engine
Side
MANUAL TRANSAXLE (S51)
REASSEMBLY
HINT:
Coat all of the sliding and rotating surfaces with gear oil before
reassembly.
1. INSTALL NO.2 CLUTCH HUB INTO HUB SLEEVE
(a) Install the clutch hub and shifting keys to the hub sleeve.
(b) Install the shifting key springs under the shifting keys.
NOTICE:
Position the key springs so that their end gaps are not
SM0282
aligned.
2. INSTALL 3RD GEAR, NEEDLE ROLLER BEARING,
SYNCHRONIZER RING AND NO.2 HUB SLEEVE AS-
SEMBLY TO INPUT SHAFT
(a) Apply gear oil to the needle roller bearings.
(b) Place the synchronizer ring (for the 3rd gear) on the gear
and align the ring slots with the shifting keys.
NOTICE:
Do not install the synchronizer ring for 4th gear.
SM0193
(c) Using a press, install the 3rd gear and No.2 hub sleeve.
Z00419
3. INSTALL SNAP RING
(a) Select a snap ring that allows the minimum axial play.
Z00604
– INPUT SHAFT
Mark
1
2
3
4
5
6
Author :
Thickness mm (in.)
1.95–2.00 (0.0768–0.0787)
2.00–2.05 (0.0787–0.0807)
2.05–2.10 (0.0807–0.0827)
2.10–2.15 (0.0827–0.0846)
2.15–2.20 (0.0846–0.0866)
2.20–2.25 (0.0866–0.0886)
Date :
MX–25
MX04M–01
1875