Toyota Camry Manual page 2041

EM–42
ENGINE MECHANICAL (5S–FE)
INSPECTION
1.
(a)
A07356
(b)
(c)
CAUTION:
Protect your eyes when using high–pressure compressed
air.
2.
A07357
3.
(a)
NOTICE:
Be careful not to scratch the cylinder block contact sur-
face.
P03267
(b)
NOTICE:
Be careful not to scratch the cylinder block contact sur-
face.
P03268
(c)
P03149
– CYLINDER HEAD
CLEAN TOP SURFACES OF PISTONS AND CYL-
INDER BLOCK
Turn the crankshaft, and bring each piston to top dead
center (TDC). Using a gasket scraper, remove all the car-
bon from the piston top surface.
Using a gasket scraper, remove all the gasket material
from the cylinder block surface.
Using compressed air, blow carbon and oil from the bolt
holes.
INSPECT TOP SURFACE OF CYLINDER BLOCK FOR
FLATNESS (See page EM–97)
CLEAN CYLINDER HEAD
Using a gasket scraper, remove all the gasket material
from the cylinder block contact surface.
Using a wire brush, remove all the carbon from the com-
bustion chamber.
Using a valve guide bushing brush and solvent, clean all
the guide bushings.
Author :
EM08A–04
Date :
1214