Toyota Camry Manual page 2594

SF–2
Plug
SFI (1MZ–FE)
(b) When installing the battery, be especially careful not to in-
correctly connect the positive (+) and negative (–) cables.
(c) Do not permit parts to receive a severe impact during re-
moval or installation. Handle all SFI parts carefully, espe-
cially the ECM.
(d) Be careful during troubleshooting as there are numerous
transistor circuit, and even slight terminal contact can
cause further troubles.
(e) Do not open the ECM cover.
(f) When inspecting during rainy weather, take care to pre-
vent entry of water. Also, when washing the engine
compartment, prevent water from getting on the SFI parts
and wiring connectors.
(g) Parts should be replaced as an assembly.
(h) Care should be taken when pulling out and inserting wir-
ing connectors.
(1)
(2)
(i) Use SST for inspection or test of the injector or its wiring
connector.
SST
SST
FI2553
8. FUEL SYSTEM
Fuel
(a) When disconnecting the high fuel pressure line, a large
Pump
amount of gasoline will spill out, so observe these proce-
Connector
dures:
(1)
(2)
S04600
(3)
(4)
(5)
(6)
S05039
– SFI SYSTEM
Release the lock and pull out the connector, pulling
on the connectors.
Fully insert the connector and check that it is locked.
09842–30070
Disconnect the fuel pump connector.
Start the engine. After the engine has stopped on
its own, turn the ignition switch to LOCK.
Put a container under the connection.
Slowly loosen the connection.
Disconnect the connection.
Plug the connection with a rubber plug.
Author : Date :
1501