Toyota Camry Manual page 1949

DI–922
E1 DLC1
TE1
Normal code
0.25 Sec.
DIAGNOSTICS
F02201
0.25 Sec.
BR3904
– ENGINE IMMOBILISER SYSTEM
2. INSPECT DIAGNOSIS
(a) Check the DTC (Using TOYOTA hand–held tester)
(1) Prepare the OBD ll scan tool (complying with SAEJ
1978) or TOYOTA hand–held tester.
(2) Connect the OBD ll scan tool or TOYOTA hand–
held tester to DLC3 under the instrument panel low-
er pad.
(3) Turn the ignition switch ON and turn the OBD ll scan
tool or TOYOTA hand–held tester switch ON.
(4) Use the OBD ll scan tool or TOYOTA hand–held
tester to check the DTCs and freeze frame data;
note them down. (For operating instructions, see
the OBD ll scan tool's instruction book.)
(5) See page
(b) Check the DTC (Using diagnosis check wire)
(1) Turn ignition switch ON.
(2) Using SST, connect between terminals 8 (TE1) and
3 (E1) of DLC1.
SST 09843–18040
(3) Read the diagnostic trouble code from malfunction
indicator lamp.
HINT:
D
If a diagnostic trouble code is not output, check the Tc ter-
minal circuit .
D
ECM controls the immobiliser function on this vehicle,
DTC is out put with DTC of engine.
As an example, the blinking patterns for codes; normal, 12 and
99 are as shown in the illustration.
Author :
DI–924 to confirm the details of the DTCs.
Date :
1157