Toyota Camry Manual page 1654

Normal Code
0.25
ON
OFF
0.25
Code 11 and 31
0.5 2.5
ON
OFF
1.5 0.5
DTC 11 DTC 31
AT0716
AB0056
DLC1
TOYOTA Hand–Held Tester
DLC3
H08398
S05331
DIAGNOSTICS
(c)
If there are 2 or more codes, there will be a 2.5–second pause
4.0
between each code. After all the codes have been output, there
will be a 4.0–second pause and they will all be repeated.
HINT:
D
Repeat
D
H08231
3.
(a)
(b)
HINT:
Please refer to the TOYOTA hand–held tester operator's manu-
al for further details.
4.
When the ignition switch is turned off, the diagnostic trouble
code is cleared.
HINT:
DTC might not be cleared by turning the ignition switch OFF.
In this case, proceed to the next step.
5.
(a)
(b)
H08323
– SUPPLEMENTAL RESTRAINT SYSTEM
Read the DTC.
Read the 2–digit DTC as indicated by the number of times
the SRS warning light blinks. As an example, the blinking
patterns, normal, 11 and 31 are shown in the illustration.
D
Normal code indication
The light will blink 2 times per second.
D
Malfunction code indication
The first blinking output indicates the first digit
of a 2–digit DTC. After a 1.5–second pause,
the second blinking output will indicate the
second digit.
In the event of a number of trouble codes, indication will
start from the smallest numbered code.
If a DTC is not output or a DTC is output without terminal
connection, proceed to the Tc terminal circuit inspection
on page DI–796.
DTC CHECK (Using TOYOTA hand–held tester)
Hook up the TOYOTA hand–held tester to the DLC1 or
the DLC3.
Read the DTCs by following the prompts on the tester
screen.
DTC CLEARANCE (Not using service wire)
DTC CLEARANCE (Using service wire)
Connect the 2 service wires to terminals Tc and AB of
DLC1.
Turn the ignition switch to ACC or ON and wait for approx.
6 seconds.
Author :
DI–627
Date :
862