Toyota Camry Manual page 2079

EM–80
ENGINE MECHANICAL (5S–FE)
(b)
(c)
(d)
(e)
(f)
(g)
(h)
(i)
(j)
(k)
(l)
(m)
(n)
(o)
(p)
(q)
(r)
(s)
(t)
33.
(a)
(b)
(c)
(d)
S05251
(e)
(f)
34.
35.
36.
37.
Install the air cleaner case with the 3 bolts.
– ENGINE UNIT
Connect the generator connector.
Install the wire clamp to the generator.
Connect the starter cable.
Connect the starter connector.
Install the DLC1 to the bracket.
Install the engine wire clamp to the bracket on the RH
fender apron.
Connect the MAP sensor connector.
Install the wire clamp to the bracket for the MAP sensor.
Connect the VSV connector for the vapor pressure sen-
sor.
Connect the 2 ground strap connectors to the RH fender
apron.
Connect the 2 ground strap connectors to the LH fender
apron.
Install the engine wire protector clamp to the battery
bracket.
Install the engine wire to the clamp on the fuel filter.
Connect the ground cable to the transaxle.
Connect the brake booster vacuum hose to the intake
manifold.
Connect the heater hose to the water outlet.
Connect the heater hose to the water bypass pipe.
Connect the fuel inlet hose to the fuel filter with 2 new gas-
kets and the union bolt.
Torque: 29 N·m (300 kgf·cm, 21 ft·lbf)
Connect the MAP sensor vacuum hose to the gas filter on
the intake manifold.
INSTALL FRONT EXHAUST PIPE
Install the support bracket with the nut.
Torque: 33 N·m (330 kgf·cm, 24 ft·lbf)
Temporarily install 2 new gaskets and the front exhaust
pipe with the 2 bolts and 5 nuts.
Tighten the 3 nuts holding the exhaust manifold to the
front exhaust pipe.
Torque: 62 N·m (630 kgf·cm, 46 ft·lbf)
Tighten the 2 bolts and 2 nuts holding the front exhaust
pipe to the center exhaust pipe.
Torque: 56 N·m (570 kgf·cm, 41 ft·lbf)
Install the bracket with the 2 bolts.
Torque: 33 N·m (330 kgf·cm, 24 ft·lbf)
Install the support stay with the 2 bolts.
Torque: 33 N·m (330 kgf·cm, 24 ft·lbf)
INSTALL RADIATOR (See page CO–23)
INSTALL CRUISE CONTROL ACTUATOR
INSTALL BATTERY TRAY AND BATTERY
INSTALL AIR CLEANER CASE
Author : Date :
1252