Toyota Camry Manual page 2105

Hide thumbs Also See for Camry:

Table of Contents

Cut position

ENGINE MECHANICAL (5S–FE)

there are 2 methods ((a) and (b)) to replace the oil seal.

Be careful not to damage the crankshaft. Tape the screw-

CYLINDER BLOCK

REPLACE CRANKSHAFT REAR OIL SEAL

If the rear oil seal retainer is removed from the cylinder

Using a screwdriver and hammer, tap out the oil

Using SST and a hammer, tap in a new oil seal until

its surface is flush with the rear oil seal retainer

09223–15030, 09950–70010 (09951–07100)

Apply MP grease to the oil seal lip.

If rear oil seal retainer is installed to cylinder block:

Using a knife, cut off the oil seal lip.

Using a screwdriver, pry out the oil seal.

Apply MP grease to a new oil seal lip.

Using SST and a hammer, tap in the oil seal until its

surface is flush with the rear oil seal retainer edge.

09223–15030, 09950–70010 (09951–07100)

Show Quick Links

Table of Contents