Toyota Camry Manual page 2052

8 6 1
10 4 2
90°
90°
Front
Painted
Mark
ENGINE MECHANICAL (5S–FE)
INSTALLATION
1.
(a)
NOTICE:
Be careful of the installation direction.
(b)
A07355
2.
HINT:
(a)
(b)
3 9
If any one of the cylinder head bolts does not meet the torque
specification, replace the cylinder head bolt.
5 7
Z02750
(c)
(d)
(e)
(f)
(g)
S01690
3.
(a)
(b)
(c)
P03279
– CYLINDER HEAD
PLACE CYLINDER HEAD ON CYLINDER BLOCK
Place a new cylinder head gasket on the cylinder block.
Place the cylinder head on the cylinder head gasket.
INSTALL CYLINDER HEAD BOLTS
The cylinder head bolts are tightened in 2 progressive
steps (steps (b) and (d)).
If any cylinder head bolt is broken or deformed, replace
it.
Apply a light coat of engine oil on the threads and under
the heads of the cylinder head bolts.
Install and uniformly tighten the 10 cylinder head bolts
and plate washers in several passes, in the sequence
shown.
Torque: 49 N·m (500 kgf·cm, 36 ft·lbf)
Mark the front of the cylinder head bolt head with paint.
Retighten the cylinder head bolts 90° in the numerical or-
der shown.
Check that the painted mark is now at a 90° angle to the
front.
Install the 2 bolts holding the water bypass pipe to the cyl-
inder head.
Torque: 19 N·m (195 kgf·cm, 14 ft·lbf)
Connect the camshaft position sensor connector.
INSTALL SPARK PLUG TUBES
Clean the cylinder head tube holes of any residual adhe-
sive, oil or foreign particles. Remove any oil with kerosene
or gasoline.
Screw the threads of the spark plug tube coated with
adhesive into the cylinder head.
Using the spark plug tube nut and a 30 mm socket
wrench, tighten the spark plug tubes.
Torque: 49 N·m (500 kgf·cm, 36 ft·lbf)
Author :
EM–53
EM08D–04
Date :
1225