Toyota Camry Manual page 2046

Hide thumbs Also See for Camry:

Table of Contents

ENGINE MECHANICAL (5S–FE)

Free Distance

CYLINDER HEAD

Using a spring tester, measure the tension of the valve

spring at the specified installed length.

Installed tension:

164 – 189 N (16.7 – 19.3 kgf, 36.8 – 42.5 lbf)

at 34.7 mm (1.366 in.)

If the installed tension is not as specified, replace the valve

INSPECT CAMSHAFTS

Inspect the circle runout.

Place the camshaft on V–blocks.

Using a dial indicator, measure the circle runout at

the center journal.

Maximum circle runout: 0.04 mm (0.0016 in.)

If the circle runout is greater than maximum, replace the cam-

Using a micrometer, measure the cam lobe height.

Standard cam lobe height:

Minimum cam lobe height:

If the cam lobe height is less than minimum, replace the cam-

Using a micrometer, measure the journal diameter.

Journal diameter:

26.959 – 26.975 mm (1.0614 – 1.0620 in.)

If the journal diameter is not as specified, check the oil clear-

Using vernier calipers, measure the free distance be-

tween the gear spring ends.

Free distance: 22.5 – 22.9 mm (0.886 – 0.902 in.)

If the free distance is not as specified, replace the gear spring.

42.01 – 42.11 mm (1.6539 – 1.6579 in.)

40.06 – 40.16 mm (1.5772 – 1.5811 in.)

41.90 mm (1.6496 in.)

39.95 mm (1.5728 in.)

Show Quick Links

Table of Contents