Toyota Celica 2005 Repair Manual page 954

INSPECTION PROCEDURE
"M" position indicator light flashes.
When the ATF temperature is too high or low, the M position indicator light flashes. If this happens, shift the
shift lever to the D position and shift it back to the M position after the ATF temperature increase or decrease.
If the M position indicator light is still flashing, check if DTC P0710, P0712, or P0713 is displayed or not and
inspect the transmission shift main switch circuit.
"M" position indicator light does not light up.
1 Check E−shift main switch.
3
OK
2 Check and replace the combination meter (See page BE−50).
OK
2005 CELICA (RM1131U)
DIAGNOSTICS
PREPARATION:
Remove the E−shift main switch.
CHECK:
Check continuity between each terminal of the E−shift main
4
switch.
OK:
Shift Lever Position
D07811
NG
NG
− AUTOMATIC TRANSAXLE (U240E)
Tester connection
M
Except M
Replace the E−shift main switch
(See page AX−17).
Replace the combination meter.
953
Specified value
3 − 4 Continuity
3 − 4 No continuity
DI−753