Installing Endshields - MacDon D65 Operator's Manual

Installing Endshields

1. Position the endshield onto support (A), and align the
hole in the endshield with the stud (B) on the support.
2. Secure the endshield to the support with acorn nut (A).
3. Close the endshield.
page 36.
NOTE:
Plastic endshields may expand or contract when
subjected to large temperature changes. Top pin
and lower catch bracket positions can be adjusted
to compensate for dimensional changes. Refer to
Adjusting Endshields, page
147725
OPERATION
Refer to Closing Endshields,
39.
Figure 3.14: Left-Hand Endshield
Figure 3.15: Left-Hand Endshield
38
Revision A