Installing Endshields - MacDon D65 Operator's Manual

Installing Endshields

To install an endshield, follow these steps.
1. Position endshield on support (A) and align the hole in
the endshield with stud (B) on the support.
2. Secure endshield to the support with acorn nut (A).
3. Close endshield. See
NOTE: Plastic endshields
expansion, or contraction depending on
large temperature variations.
and lower latch bracket positions can be
adjusted to compensate for dimensional
changes.
page 41.
169594
OPERATION
Closing Endshields, page
are subject
Top pin
See Adjusting Endshields,
Figure 4.14
38.
to
Figure 4.15
40
Rev. C