Installing Endshields - MacDon D65 Operator's Manual

Installing Endshields

To install an endshield, follow these steps.
1. Position endshield on support (A) and align the hole in
the endshield with stud (B) on the support.
2. Secure endshield to the support with acorn nut (A).
3. Close endshield. Refer to
38.
NOTE:
Plastic endshields are subject to expansion, or
contraction depending on large temperature variations.
Top pin and lower latch bracket positions can be adjusted
to compensate for dimensional changes. Refer to
Adjusting Endshields, page
169899
OPERATION
Closing Endshields, page
41.
Figure 4.14: Endshield
Figure 4.15: Endshield
40
Revision A