Chapter 4: Header Attachment/Detachment; Attaching Header To Windrower - MacDon D65 Operator's Manual

Chapter 4: Header Attachment/Detachment

This chapter includes instructions for attaching a header to, and detaching a header from a windrower.

4.1 Attaching Header to Windrower

Refer to your windrower operator's manual for instructions for mechanically attaching the header to the windrower.
Refer to the following procedures for electrical and hydraulic connections.
Header drive hydraulic hoses and electrical harness are located on the left cab-forward side of the windrower. The reel
drive and control hoses are located on the right cab-forward side.
1. Before connecting header drive hydraulics (A) and electrical
harness (B) to header, check fittings and connectors. Clean
them if required.
2. Disengage and rotate lever (A) counterclockwise to fully up
position.
3. Remove cap (B) securing the electrical connector to
the frame.
4. Move hose bundle (C) from the windrower hose support
and route it along the header hose guide.
214327
B
Figure 4.1: Header Drive Hoses
Figure 4.2: Header Drive Hoses
113
A
A
B
C
Revision B