Header Attachment/Detachment; Attaching Header To Windrower - MacDon D65 Operator's Manual

4 Header Attachment/Detachment

This chapter includes instructions for setting up, attaching, and detaching the header.

4.1 Attaching Header to Windrower

Refer to your windrower operator's manual for instructions for mechanically attaching the header to the
self-propelled windrower.
Refer to the following procedures for electrical and hydraulic connections.
Header drive hydraulic hoses and electrical harness are located on the left cab-forward side of the windrower. The
reel drive and control hoses are located on the right cab-forward side.
To attach the header to a windrower, follow these steps:
1. Before connecting header drive hydraulics (A) and
electrical harness (B) to header, check connectors and
clean if required.
2. Disengage and rotate lever (A) counterclockwise to
fully up position.
3. Remove cap (B) securing electrical connector to frame.
4. Move hose bundle (C) from windrower around hose
support on header.
147725
Figure 4.1: Header Drive Hoses
Figure 4.2: Header Drive Hoses
105
Revision A