Header Attachment/Detachment; Attaching Header To Windrower - MacDon D65 Operator's Manual

5 Header Attachment/Detachment

This chapter includes instructions on setting up, attaching, and detaching the header.

5.1 Attaching Header to Windrower

Refer to your windrower
procedures to mechanically attach the header to the
self-propelled windrower.
Refer to the following procedures for electrical and
hydraulic connections.
Header drive hydraulic hoses and electrical harness are
located on the left cab-forward side of the tractor. The
reel drive and control hoses are located on the right
cab-forward side.
To attach the header to a windrower, follow these steps:
1. Before connecting header drive hydraulics (A) and
electrical harness (B) to header, check connectors and
clean if required.
2. Disengage and rotate lever (A) counterclockwise to
fully up position.
3. Remove cap (B) securing electrical connector to frame.
4. Move hose bundle (C) from windrower around hose
support on header.
169594
operator's manual for
105
Figure 5.1
Figure 5.2
Rev. C