Leveling Header - MacDon M2170NT Operator's Manual

Settings for the fore-aft, reel height, and header height are
limited as follows to prevent the reel from contacting the
cab roof:
• If you increase the reel height (B) to greater than 7.0 while
the reel fore-aft (C) is greater than 5.0, and the header
height (A) is greater than 7.0, the reel fore-aft will
automatically move forward to 5.0 or less to avoid colliding
with the cab roof.
• After the reel fore-aft automatically moves, you will then
have to manually adjust the fore-aft.
NOTE:
If you try to move the reel fore-aft so the value would
exceed 5.0, message (D) will show on the HarvestTouch
Display.
• For instructions about operating the reel fore-aft, refer to
5.5.3 Adjusting Reel Fore-Aft Position, page

5.5.5 Leveling Header

The windrower lift linkages are factory-set to provide the proper header level and should not normally require adjustment.
DANGER
To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the
key from the ignition before leaving the operator's seat for any reason.
If the header level needs to be adjusted, follow these steps:
1. Remove the float spring tension to ensure that the lift windrower linkages are not affected by the float springs. For
instructions, refer to Removing and Restoring Float, page
DANGER
Ensure that all bystanders have cleared the area.
262171
OPERATION
™
251.
Figure 5.124: HarvestTouch
Shown
240.
253
B
A
D
Display – Draper Header
™
C
Revision A