Setting The Header Lower Rate To 50 (New Holland Cr/Cx Series); Setting The Sensitivity Of The Auto Header Height Control To 200 (New Holland Cr/Cx Series) - MacDon FFT FlexDraper FD75 Operator's Manual

1. Select HEADER RAISE RATE on the combine
display screen.
2. Use the '+' or '–' buttons to change the setting.
3. Press ENTER to save the new setting.
NOTE:
The raise rate can be changed from 32–236 in
steps of 34. The factory setting is 100.

Setting the Header Lower Rate to 50 (New Holland CR/CX Series)

If necessary, the header lower rate (the automatic header height control button or second speed on the header
height rocker switch of the multi-function handle) can be adjusted.
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to
the combine operator's manual for updates.
1. Select HEADER LOWER RATE on the combine
display screen.
2. Use the '+' or '–' buttons to change the setting to 50.
3. Press ENTER to save the new setting.
NOTE:
The lower rate can be changed from 2–247 in
steps of 7. It is factory set to 100.

Setting the Sensitivity of the Auto Header Height Control to 200 (New Holland CR/CX Series)

NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to
the combine operator's manual for updates.
To set the Auto Header Height Control sensitivity, follow these steps:
147695
OPERATION
Figure 3.258: Combine Display
Figure 3.259: Combine Display
170
Revision A