Installing Crop Dividers Without Latch Option Onto Header - MacDon D65 Operator's Manual

4. Position crop divider as shown by inserting lugs (A) into
holes in endsheet.
5. Lift forward end of crop divider until pin (B) at top of
crop divider engages and closes latch (C).
6. Push safety lever (D) downwards to lock pin into
latch (C).
7. Pull at the tip of the crop divider and ensure there is
no lateral movement. If necessary, adjust bolts (A) to
tighten crop divider and eliminate lateral movement.
8. Close or install endshields. Refer to
page 35.

Installing Crop Dividers without Latch Option onto Header

DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine,
remove key, and engage safety props before going under header for any reason.
1. Lower reel, raise header, stop engine, remove key, and engage safety props. For instructions, refer to your
windrower operator's manual.
2. Open or remove endshields. Refer to
147725
OPERATION
Figure 3.52: Crop Divider
3.2.3 Endshields,
Figure 3.53: Crop Divider
3.2.3 Endshields, page
70
35.
Revision A