Installing Crop Dividers On Header Without Latch Option - MacDon D65 Operator's Manual

7. Check that divider does NOT move laterally. Adjust
bolts (A) as required to tighten divider and remove
lateral play when pulling at divider tip.
8. Close endshield.

Installing Crop Dividers on Header without Latch Option

To install crop dividers on a header without the latch option, follow these steps.
DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine,
remove key, and engage safety props before going under header for any reason. See your windrower
operator's manual for instructions for use and storage of header safety props.
1. Raise header, stop engine, remove key, and engage
safety props. For instructions, see the windrower
operator's manual.
2. Open endshield. See Section
37.
3. Remove crop divider from storage.
4. Position crop divider as shown by locating lugs (A) in
holes in endsheet.
169594
OPERATION
4.2.3 Endshields, page
72
Figure 4.54
Figure 4.55
Rev. C