Ip Pim Bsr-Candidate - Dell Z9500 Command Reference Manual

Hide thumbs Also See for Z9500:

Table of Contents

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

This command is applied to the subsequent PIM-BSR. Existing BSR advertisements

are cleaned up by time-out. To clean the candidate RP advertisements, use the

clear ip pim rp-mapping command.

ip pim bsr-candidate

To join the Bootstrap election process, configure the PIM router.

ip pim [vrf vrf-name] bsr-candidate interface [hash-mask-

length] [priority]

To return to the default value, use the no ip pim bsr-candidate [vrf vrf-

name] command.

vrf vrf-name

PIM-Sparse Mode (PIM-SM)

Introduced on the S6000-ON.

Introduced on the Z9500.

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

Introduced on the E-Series ExaScale.

Introduced on the S-Series.

(OPTIONAL) Enter the keyword vrf followed by the name of

the VRF to configure the PIM router on a VRF.

Enter the following keywords and slot/port or number

information:

For a Loopback interface, enter the keyword loopback

then a number from 0 to 16383.

For a Port Channel interface, enter the keywords port-

channel then a number. The range is from 1 to 512.

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

For a VLAN, enter the keyword vlan then a number from