Ip Pim Bsr-Candidate - Dell Z9500 Reference Manual

Hide thumbs Also See for Z9500:

Table of Contents

This command is applied to the subsequent PIM-BSR. Existing BSR advertisements

are cleaned up by time-out. To clean the candidate RP advertisements, use the

clear ip pim rp-mapping command.

ip pim bsr-candidate

To join the Bootstrap election process, configure the PIM router.

ip pim [vrf vrf-name] bsr-candidate interface [hash-mask-

length] [priority]

To return to the default value, use the no ip pim bsr-candidate [vrf vrf-

name] command.

vrf vrf-name

PIM-Sparse Mode (PIM-SM)

Introduced on the Z9500.

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

Introduced on the E-Series ExaScale.

Introduced on the S-Series.

(OPTIONAL) Enter the keyword vrf followed by the name of

the VRF to configure the PIM router on a VRF.

Enter the following keywords and slot/port or number

information:

For a Loopback interface, enter the keyword loopback

then a number from 0 to 16383.

For a Port Channel interface, enter the keywords port-

channel then a number. The range is from 1 to 512.

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

For a VLAN, enter the keyword vlan then a number from

(OPTIONAL) Enter the hash mask length. The range is from

zero (0) to 32. The default is 30.

(OPTIONAL) Enter the priority used in Bootstrap election

process. The range is from zero (0) to 255. The default is