Ntp Authenticate - Dell C9000 Series Reference Manual

ntp authenticate

Enable authentication of NTP traffic between the switch and the NTP time serving hosts.
C9000 Series
Syntax
ntp authenticate
To disable NTP authentication, use the no ntp authentication command.
Defaults Not enabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
6.1.1.0
Usage Information You also must configure an authentication key for NTP traffic using the ntp
authentication-key command.
Related
ntp authentication-key
Commands
ntp trusted-key
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— configures the authentication key for NTP traffic.
— configures a key to authenticate.
System Time and Date 2165