Table of Contents
Advertisement
Bert Sync
Select Information Valid Indicates the information validity for the SELT operation conducted on the Xcvr.
Select Loop Length
Select Loop End
Select Loop Gauge
Select the port ID from the DSL Port drop-down list to view a specified DSL's physical Layer
Info. Click on
3.9.2 Channel Layer Info
Allow users to view the Channel layer information of a specified DSL port from the IP
DSLAM. Double Click on "Channel Layer Info" from the Function List Window. The
Channel Layer Info window appears.
Field
Interleave delay
Previous TX rate
Current TX rate
CRC block length
Current Atm Status
Rs Symbols
Rs Depth
Rs Redundency
Select the port ID from the DSL Port drop-down list view a specified DSL's channel Layer
Info. Click on
IP DSLAM
Indicates whether the Signal is in Sync or not.
Indicates the LOOP Length in Feet once when the SELT information is valid on
the Xcvr.
Indicates whether the loop is short or open once when the SELT information is
valid on the Xcvr.
Indicates the LOOP wire gauge information once, when the SELT information is
valid on the Xcvr.
to close the window.
Definition
Interleave delay for this channel. (milli-seconds)
Previous actual transmit rate on this channel if ADSL loop retain. (kbps)
Actual transmit rate on this channel. (kbps)
The length of the channel data-block on which the CRC operates.
Indicates the current ATM Status.
Indicates the number of DMT symbols per Reed-Solomon code word (S),
in the downstream direction.
Indicates interleaving depth (D), in the downstream direction.
Indicates the number of redundant bytes (R), per Reed-Solomon code in
the downstream direction
to close the window.
71
Advertisement
Table of Contents
