Table of Contents
Advertisement
Conf PML2 ATPR (dB/10)
Conf PML2 Min Rate(bps)
MSG Min Ds
Min Snr Mrg(dB/10)
FrontEnd H/W Design
H/W Pwr Reduction
GsUsBitSwap
Minimum INP
PML2 Entry Thresh Rate
PML2 Exit Thresh Rate
PML2 Entry Rate Min Time
CabinetHsEnable
GsSeltLoopType
GsRxStartBinU1
GsRxEndBinU1
PSD MoD Enable
PsdMod FallBackEnable
IP DSLAM
between an Entry into the L2 state and the first Power Trim in the
L2 state and between two consecutive Power Trims in the L2
State. It ranges from 0 to 255 seconds.
PM configuration parameter, related to the L2 low power state.
This parameter represents the maximum aggregate transmit
power reduction (in dB) that can be performed through a single
Power Trim in the L2 state. It ranges from 0 dB/10 to 310 dB/10.
PM configuration parameter, related to the L2 low power state.
This parameter specifies the minimum net data rate during the low
power state (L2). The data rate is coded in bit/s, and can range
from 0x1F40 (8000) bps to 0xFA000 (1024000) bps.
Configures downstream overhead channel bandwidth. This
feature is not supported by DSLPHY as yet.
Atuc Configured Minimum Signal/Noise Margin. This is the Noise
Margin, the modem must achieve with a BER of 10 to the power -7
or better, to successfully complete initialization. The default value
mentioned is an indicative value only.
Front end hardware reference design
Hardware configuration parameter
This parameter enables/disables upstream bit swapping
Parameter used to specify the minimum impulse noise protection
for the downstream bearer channel.
PM config param. L2 state entry data rate.
PM config param. L2 state exit data rate.
PM config param.Min L2 entry rate time
Enable/Disable HS tones in Cabinet mode
Conexant parameter that is used to specify the loop type for
SELT. The default value mentioned is an indicative value only.
Conexant parameter that specifies lowest bin number allowed for
Rx signal in G.Span Plus SUQ mode. By selecting the receive
start and end bin numbers, the user can limit the bins for special
configurations.(length = 4 bytes)
Conexant parameter that specifies highest bin number allowed for
Rx signal in G.Span Plus SUQ mode. By selecting the receive
start and end bin numbers, the user can limit the bins for special
configurations.(length = 4 bytes)
Conexant parameter that is used to configure the switching point
between DBM-OL and XOL.(length = 4 bytes)
Conexant parameter used to enable Mask on Demand (MoD)
fallback mode. When enabled, the system chooses MoD or the
299
Advertisement
Table of Contents
