Modify Clfr Tree Node - Planet IP DSLAM IDL-2400 User Manual

5.13.13.2 Modify clfr tree node

Description:
Use this command to get.
Command Syntax:
modify clfr tree node tname <tname-val>pid <pid-val>nodeid <nodeid-val>
[ descr <descry-val> ] [ offset <offset-val> ] [ mask <mask-val> ] [ value
<value-val> ] [act Drop|Fwd|FwdToCtl|CpToCtl|Eq|Gt|Lt|InRange |TerCmp|
SetPrio|MatchInList|AccDeny|SetBase|Count| Retagprio |
MatchIngenlist|GoToNextRule| allow] [valend valend ] [sbasetype Abs | Add |
Compute] [ shiftcnt <shiftcnt-val> ] [ mplr <mplr-val> ] [valtype
U8|U16|U32|U64|AtmIf|Aal5Vc|EoaIf|EthIf|Dir|Prio|Len|vlanid][ sbvarindex
l2start|l3start ] [nodeprio low]
Parameter:
Name
tname tname
pid pid
nodeid nodeid
descr descr
offset offset
362
Description
Name of the classifier tree
Type: Modify -- Mandatory
Get -- Optional
Default value: -----
Profile Id. It should be unique within a tree.
Type: Modify -- Mandatory
Get -- Optional
Valid values: 1 - 0xffffffff
Default value: -----
Node Id, should be unique within a profile
Type: Modify -- Mandatory
Get -- Optional
Valid values: 1 - 0xffffffff
Default value: -----
Description of the tree node. If the ActVal is FwdToCtl or CpToCtl
then this field is mandatory and it can be used by the applications to
receive the packets coming from control plane because of this node.
Type: Modify -- Optional
Default value: -----
OffSet, in the packet with respect to the base offset, from where we
have to take the value, which is to be matched. If ActVal is SetBase
and SBaseType is Compute then this value is used to specify the
offset with respect to the base offset, which shall be used to specify
the field of the packet used to compute the new base offset. If the
IDL series User Guide