Planet IP DSLAM IDL-2400 User Manual page 504

nature dynamic | static
enable | disable
Example:
$ create pppoe intf ifname pppoe-0 lowif ppp-0 wanbridgeport 1 sessionid 10
acmacaddr 00:30:4F:61:C1:BE macaddrprof 1 servicenameprof 2 acnameprof 4
ethpkttype Type2 nature dynamic 0x1 enable
Output:
Verbose Mode On
Entry Created
Ifname
WAN Bridge Port
AC Mac Addr
Service Name Profile : 2
AC Name Prof
Eth Pkt Type
Oper Status
Verbose Mode Off:
Entry Created
Output Fields
FIELD
Ifname
Low If Name
WAN Bridge Port
504
Default value: Type2
Specifies if the interface is dynamic or static in nature. The session is
assumed to be in established state when the interface is static in
nature.
Type: Create － Optional
Modify － Optional
Default value: dynamic
Administrative status of the interface.
Type: Create － Optional
Modify － Optional
Valid values: enable, disable
Default value: enable
: pppoe-0
: 1
: 00:30:4F:61:C1:BE Mac Addr Prof : 1
: 4
: Type2
: Up
Description
The PPPoE Interface.
This specifies the lower interface index. It contains the
ifindex of the PPP relay interface.
WAN side bridge port. A value of zero means any WAN
side port is acceptable. Currently, only value zero is
supported.
Low If Name : ppp-0
Session Id : 10
Nature : dynamic
Admin Status : Enable
IDL series User Guide