X Cli Commands; Specifying Radius Servers; Specifying The Radius Key; Configuring 802.1X Authentication - Planet IP DSLAM IDL-2400 User Manual

802.1X CLI commands

Specifying RADIUS Servers

To specify one or more RADIUS servers, perform this task in privileged mode:
Step 1 Specify the IP address of up to three RADIUS
servers. Specify the primary server using the
primary keyword. Optionally, specify the destination
UDP port to use on the server.
Step 2 Verify the RADIUS server configuration.

Specifying the RADIUS Key

Use the RADIUS key to encrypt and authenticate all communication between the
RADIUS client and server. You must configure the same key on the client and the
RADIUS server.
The length of the key is limited to 65 characters. It can include any printable ASCII
characters except tabs.
To specify the RADIUS key, perform this task in privileged mode:
Step 1 Specify the RADIUS key that is used to encrypt
packets that are sent to the RADIUS server.
Step 2 Verify the RADIUS configuration.

Configuring 802.1X Authentication

The following sections describe how to configure 802.1X authentication on the switch.
IP DSLAM
Task
Task
Command
create radius server
ip_addr [acct-port
port_number] [primary]
get radius
Command
create radius key key
get radius
703