Planet IP DSLAM IDL-2400 User Manual page 656

Example:
$ get vlan curr info vlanid 45
Output:
VLAN Index
VLAN Status
Egress Ports
Untagged Ports
Bridging Mode
Flood support Status
Broadcast support Status
Reserved Mac Profile Id
Output field:
Field
VLAN Index
VLAN Status
Egress Ports
Untagged Ports
Bridging Mode
656
: 45
: 1
: 24
: 24
: Residential
: enable
: enable
: 1
Description
The VLAN identifier
This value indicates the status of the VLAN Port
corresponding to this entry. Other (1) - the entry is
for the default VLAN created for the system.
Permanent (2) - this entry, corresponding to an
entry in dot1qVlanStaticTable, is currently in use
and will remain so after the next reset of the
device. The port lists for this entry include ports
from the equivalent dot1qVlanStaticTable entry
and ports learnt dynamically. Dynamic (3) - this
entry is currently in use and will remain so until
removed by GVRP. There is no static entry for
this VLAN and it will be removed when the last port
leaves the VLAN.
The set of ports, which are transmitting traffic for
this VLAN, as either tagged or untagged frames.
The set of ports, which are transmitting traffic for
this VLAN as untagged frames. In Stacked Vlan
mode this applies tagging/untagging for C-VLAN.
This specifies the state of full bridging for the Vlan.
There can be 3 values associated with this based
on global fullBridgingStatus. These values can
be restricted bridging, unrestricted full bridging and
residential bridging. The user can specify the
bridging mode for the vlan in the
Dot1qVlanStaticTable table as one of these
IDL series User Guide