Table of Contents
Advertisement
dstportto
<dstportto-val >
srcportcmp eq | neq |
lt | leq | gt | geq | any |
inrange | exrange
dstportcmp eq | neq |
lt | leq | gt | geq | any |
inrange | exrange
subruleprio low | high
|asinrule
transporthdr ethernet
| pppoe
Example:
$ create filter subrule udp ruleid 1 subruleid 2 srcportfrom 21 srcportto 23
dstportfrom 21 dstportto 23 srcportcmp inrange dstportcmp inrange subruleprio
high
IP DSLAM
udp destination port numbers, if 'dstportcmp' is either 'inrange' or
'exrange'
Type: Create -- Optional
Modify -- Optional
Default value: 0
End port number of the range of destination port numbers. This field
and 'dstportfrom' specifiy a range of udp destination port numbers, if
'dstportcmp' is either 'inrange' or 'exrange'.Otherwise this field is invalid
Type: Create -- Optional
Modify -- Optional
Default value: 65535
Source port comparison type
Type: Create -- Optional
Modify -- Optional
Default value: any
Destination port comparison type
Type: Create -- Optional
Modify -- Optional
Default value: any
This specifies the priority of the subrule. Based on this priority value,
the subrule is created in fast or slow memory. In case priority is
specified as 'asinrule', subrule priority will be same as specified in the
rule.
Type: Create -- Optional
Modify -- Optional
Default value: asinrule
This specifies the type of the transport header in the packet in which
the corresponding IP is being transported. If the value of this field is
Ethernet, then the IP is being carried in the Ethernet header. If it is
PPPoE, then the corresponding IP is being carried in the PPP header.
Type: Create -- Optional
Modify -- Optional
Default value: Ethernet
445
Advertisement
Table of Contents
