Planet IP DSLAM IDL-2400 User Manual page 284

<atucintlmintxrate-val>
atucfastmaxtxrate
<atucfastmaxtxrate-val>
atucintlmaxtxrate
<atucintlmaxtxrate-val>
atucmaxintldelay
<atucmaxintldelay-val>
type noChannel | fastOnly |
interleavedOnly |
fastOrInterleaved |
fastAndInterleaved
atucgstxendbin
<atucgstxendbin-val>
atucgstxstartbin
<atucgstxstartbin-val>
atucgsmaxbitsperbin
<atucgsmaxbitsperbin-val>
atucgsrxstartbin
<atucgsrxstartbin-val>
atucgsrxendbin
284
Also refer to 'adslAtucConfRateChanRatio' for information regarding
RADSL mode and refer to ATU-R transmit rate for ATU-C receive rates.
Type: Modify -- Optional
Valid values: 0 - 0xffffffff
Configured Maximum Transmit rate for 'Fast' channels, in bps. Also
refer to 'adslAtucConfRateChanRatio' for information regarding RADSL
mode and ATU-R transmit rate for ATU-C receive rates.
Type: Modify -- Optional
Valid values: 0 - 0xffffffff
Configured Maximum Transmit rate for 'Interleave' channels, in bps.
Also refer to 'adslAtucConfRateChanRatio' for information regarding
RADSL mode and ATU-R transmit rate for ATU-C receive rates.
Type: Modify -- Optional
Valid values: 0 - 0xffffffff
Configured maximum Interleave Delay for this channel. Interleave
delay applies only to the interleave channel and defines the mapping
(relative spacing) between subsequent input bytes at the interleaver
input and their placement in the bit stream at the interleaver output.
Larger numbers provide greater separation between consecutive input
bytes in the output bit stream, allowing for improved impulse noise
immunity at the expense of payload latency.
Type: Modify -- Optional
Valid values: 0 - 255
This object is used to configure the ADSL physical line mode.
Type: Modify -- Optional
The highest bin number allowed for Tx signal.
Type: Modify -- Optional
Valid values: 0x06 - 0xff
The lowest bin number allowed for Tx signal.
Type: Modify -- Optional
Valid values: 0x06 - 0xff
The maximum Rx number of bits per bin.
Type: Modify -- Optional
Valid values: 0 - 15
The lowest bin number allowed for Rx signal.
Type: Modify -- Optional
Valid values: 0x01 - 0x1ff
The highest bin number allowed for Rx signal.
IDL series User Guide