Table of Contents
Advertisement
Output Fields:
FIELD
Ifname
Low IfName
Max PDU Size
Ter Ack TimeOut
Lowif Toggle TimeOut
Nature
Config Status
Operational Status
Admin Status
PPPOA PacketsPrio
IP DSLAM
Description
The PPPR interface.
This specifies the name of the lower AAL5
interface.
This specifies the maximum PDU size on a PPPR
interface.
Time in seconds to wait for LCP terminate Ack,
after sending a terminate request.
Time in seconds to wait for lowif to come up
without tearing down the pppr session.
Specifies if the interface is dynamic or static in
nature.
This mode describes the configuration status for
the interface. If the "config" bit is set, this interface
shall be created, but will have a dormant status.
Only after the receipt of an pppoa packet from the
CPE side, this interface shall become active. The
"In-Use" and "Not-In-Use" bits are read-only bits.
The "Not-In-Use" bit indicates that the entry is
dormant and "In-Use" bit indicates that the entry is
activated.
The actual/current state of the interface. It may be
either Up or Down.
The desired state of the interface. It may be either
Up or Down.
Priority to be set in tagged PPPOE frames or PPP
packets sent over this port from Control
Plane .This priority shall also be used for choice of
traffic class/ Queue on outgoing interface whether
the frame is tagged or not.In case the bridge port is
over an Aggregated ATM VC, this will also be
used to identify the VC, on which the packet is to
be sent.
511
Advertisement
Table of Contents
